Liquid & Gas Analysis Instruments

It gives a continuous electrical reading of a water or process quality parameter, such as pH, disinfectant residual, dissolved oxygen, turbidity or organic load, instead of a one-off lab sample. The sensor sits in or on the pipe or tank, and a transmitter or controller converts its signal into a display, alarm and often a dosing command.

The Chemitec range covers one to eight. Series 30 is single-channel, Series 46 handles one or two parameters, and Series 50 logs up to eight simultaneous measurements with a colour display and four analogue outputs, useful when several sensors feed one monitoring point.

Most online continuous effluent monitoring setups combine pH, dissolved oxygen, suspended solids, turbidity and BOD/COD, sometimes with conductivity and chlorine. We supply the sensors and analysers; check with your integrator which models are approved for your reporting requirement.

Mostly Chemitec, for consistent wiring, output and controller compatibility across parameters. Electrodes also come from Kuntze, and biomass and turbidity NIR sensors from Exner, so the exact brand depends on which parameter and range you need.

Tell us the parameter, the expected range, the medium's temperature and pressure, and whether the liquid is clean or carries solids. We'll match it to a sensor and transmitter combination and flag any accessory, such as a retractable housing, that the installation needs.

Yes, with a retractable housing. A manual or pneumatic mechanism withdraws the sensor from the pipe or tank under pressure, so you can clean or swap it without a process shutdown. Static and immersion fittings are also available for lower-maintenance points.